Milwaukee Instruments SONAR SMS510 User Manual download pdf (Page 2)

OPERATION:

• Connect the supplied 12 VDC

power adapter to the meter

and to the mains.

• Connect the ORP electrode

to the BNC socket on the

bottom of the meter.

• Always remove the electrode

protective cap before taking

any measurement. If the elec-

trode has been left dry, soak

the tip (bottom 2.5 cm) in

rinse solution (M10000B) for

a few minutes to reactivate it.

• Turn the instrument on by

pressing the ON/OFF key.

• Allow the reading to stabilize

and the meter will start con-

tinuous monitoring.

• The meter is factory calibrated.

• A blinking alarm will indicate when the measured ORP

value is lower than the setpoint.

NOTE:

• The power contact is not protected by fuse inside the

meter. It is recommended to protect it outside, against

failure.

• WARNING: when the alarm led is blinking, the mains

voltage is present in the output power socket.

SETPOINT:

• The setpoint can be selected

by adjusting the central front

knob to the desired value.

• The selectable range for

SMS510 is from 0 to 600 mV.

INSTALLATION PROCEDURE:

1 2

No comments

Milwaukee Instruments SONAR SMS510 User Manual Page 2